null
close
close

FROM BARE PAINT TO PROTECTED IN FOUR SIMPLE STEPS

  1. Pop in the loadguard (closest part to cab)
  2. Snap in the sidewalls
  3. Lay in the ZeroSkid rubber mat into the C channel
  4. Add the tailgate protector*
  5. Thats it.

*Tailgate protector available only on truck models without factory tailgate step

MORE DETAILED INSTALLATION INSTRUCTION BELOW.


STEP 1

INSTALL THE LOADGUARD

For most truck models, the DualLiner loadguard component simply snaps into place. Since all DualLiner bedliner components are custom fit to each vehicle, the loadguard may be a bit snug. If you are having problems getting the loadguard around your trucks factory tiedowns, simply install one side, place your hand behind the loadguard, gently bend it to give you some extra room and slide the other side into position.


STEP 2

INSTALL THE SIDEWALLS

On trucks with welded-in tie downs, all you need to do is snap the sidewalls into place. If your truck has bolt-in tie downs, remove them first, snap the sidewalls into place and then re-install the tie downs. Be sure you have the sidewalls aligned properly prior to tightening the bolts.


STEP 3

UNROLL THE ZEROSKID RUBBER FLOOR

The skid-free rubber bed mat that comes with your DualLiner bed liner is easy to install. Simply lock it into the channels at the bottom of the sidewalls. The cleated bottom of the rubber mat promotes airflow and helps to prevent water from building up under the mat to deter corrosion.


STEP 4

INSTALL THE TAILGATE PROTECTOR

On most truck models, simply remove the tailgate bolts that line up with the holes in the DualLiner tailgate protector. There could be anywhere from 4 to 12 bolts, depending on your model of vehicle. Be sure not to over torque the bolts, as the sheet metal is easily stripped. Some models also ship with double-sided tape or optional drill-in pine tree fasteners for trucks with few factory bolts.

Free Ground Shipping*
Installation Available
Secure Shopping
30-Day Free Exchanges